hp error code 55,laser printer manual

Hp Error Code 55, Service Errors Codes 55 Laser Printer Repair

errors codes message tech support,diagnosis problem

 


 

     

HP LASER PRINTER ERROR CODE 55 - INTERNAL COMMUNICATION PROBLEM

ALL HP LASER PRINTERS

1. Defective dc controller board.

2. Defective formatter board.

3. Inadequate site power – surge protector. HP 4V

HP LASER PRINTER 4V

1. Defective laser scanner assembly.

HP LASER PRINTERS 3SI, 4SI 

1. Improperly fitted connectors.

2. Loose or bad cable.

3. Defective dc controller.

4. Defective dc power supply. 

5. Defective formatter board

6. Defective paper input pca board

7. Defective main motor. 

HP LASER PRINTERS 5SI, 8000, 8100, 8150

1. Loose or bad cable from D.C. controller and laser scanner ass'y.

2. Defective laser scanner assembly. 

3. Defective dc controller board.

4. Defective formatter board.

HP LASER PRINTERS 5SI, 8000, 8100, 8150 ( error 55.A )

1. Change fuser

2. Change wiring harness from the D.C. controller to the fuser ass'y.

3. Change the D.C. controller board.

HP LASER PRINTERS 1100, 2100, 4000, 4050

1. Replace the formatter board.

2.Replace the D.C. controller Board.

3.Replace the engine board


HP LASER PRINTERS 1200, 2200, 3100 FAX, 3200 FAX, 4100 

1. Defective dc controller.

2. Check the cable to the ECU.

3. Replace the ECU.

4. Defective formatter.

5. Defective firmware DIMM.

HP LASER PRINTER 2300 ERROR 55.XX AND ERROR 55.A, 55.B, 55.C, 55.D

1. No engine response.

2. Excessive glitches.

3. Communication timeout.

4. Bad tray bin reports.

5. Incoming parity error.

6. Outgoing parity error.

7. Hung communications.

8. Invalid bus timeout.

9 Try using a different printer diver or printing a smaller file.

10. Try printing from a different application. Like an email.

HP LASER PRINTERS 2410, 2420, 2430 ERROR 55.XX.YY

1. Controller error.

2. Turn the printer off and then turn the printer on again.

3. If the message persists, replace the ECU.

4. If after replacing the ECU, the message persists, replace the power supply.

HP LASER PRINTER P3005 ERROR 55.XX.YY

1. The engine is not communicating with the formatter.

2. Turn the device off and then on.

3. Verify that the flat ribbon cable between the ECU and the formatter PCA is connected correctly.

4. If the message persists, replace the ECU. If the message still persists, replace the formatter.

HP LASER PRINTER 3027M/3035

1. The print engine is not communicating with the formatter.

2. Turn the device off and then turn the device on.

3. if after turning the device off and on and the message persists, replace the ECU.

4. If after replacing ECU, the message persists, replace the high voltage power supply.

HP LASER PRINTER 3050, 3052, 3055, 3390, 3392

1. The printer has experienced an internal hardware error.

2. Turn the power off and wait 30 seconds then turn the power back on.

3. If a surge protector is being used, remove it. Plug the printer directly into the wall.

4. If the error persists, replace ECU.

HP LASER PRINTER 3200

1. Disconnect the power cable from the product, wait at least 30 seconds, then reconnect the power cable and wait for the product to initialize.

2. Check the cabling to the ECU. If the error persists, replace the ECU.

HP LASER PRINTERS 4200, 4300, 4250, 4350 FOR ERROR CODE 55.X

1. The D.C. controller is not communicating with the formatter.

2. Replace the D.C. controller board.

3. Replace the formatter board.

HP LASER PRINTER 4345MFP, 5025MFP, 5035MFP ERROR 55.XX

1.The print engine is not communicating with the formatter. The problem could be caused by a timing error or an intermittent connection.

X=00 Communication error

X=01 DC Controller memory error

X=02 Outgoing parity order

X=03 No engine response

X=04 Communications timeout

X=06 DC Controller NVRAM abnormal read/write or not accessible

2. Turn the MFP off, and then turn the MFP on.

3. Reseat the connectors between the DC controller PCA and the formatter.

4. If the problem persists, replace the DC controller PCA.

5. Replace the formatter.

HP LASER PRINTER 5000, 5100

1. An internal communication error occurred.

2. Replace the D.C. controller board.

3. Replace the formatter board

HP LASER PRINTER 5200 ERROR 55.XX

1. A printer command error has occurred.

XX Description:

01- Input device

02- DC controller memory

03- No engine response

04- Communication

2. 55.01 and 55.02 errors- Replace the DC controller.

3. 55.03 and 55.04 errors- Check the DC controller connectors.

4 If error persists, replace the DC controller.

HP COLOR LASER PRINTER 4500, 4550 ERROR 55.X

1. A communication error between the formatter and the DC controller.

2. Replace the D.C. controller board. Recalibrate the D.C controller board and the formatter board.

3. Replace the formatter board.

4. Initialize NVRAM.

HP COLOR LASER PRINTER 8500 

1. Temporary error. 

2. Communication error between printer and the controller.

3. Replace the controller board. 

HP LASER PRINTER 9000
, 9040, 9050MFP

1. Temporary error. 

2. Reseat formatter, DIMMs and EIO cards.

3. Perform an engine test.

4. Perform a service test.

5. Replace D.C. controller board

6. Replace the formatter board.

 

Home | Error Codes | Hp Printers | Toner Cartridges | Hp Printer Accessories | Hp Plotters
 

Copyright © 2011 Advanced Laser Services, Inc.