hp error code 53,repair message

Hp Error Code 53, Service Errors 53 Laser Printer Srvice

laser printer errors problems tech support

 


 

     

HP LASER PRINTER ERROR CODE 53 ACCESSORY MEMORY ERROR.

HP LASER PRINTERS 2, 2D

1. Accessory memory failure.

2. Replace memory card

HP LASER PRINTERS 3, 3D

1. Failure in front memory slot. 

2. Failure in rear memory slot. 

3. Replace memory card

4. Replace formatter board.

HP LASER PRINTERS 2P, 2P+, 3P

1. Replace top memory card.

2. Replace bottom memory card.

HP LASER PRINTERS 3SI, 4SI

1. Temporary error.

2. Laser malfunction (see error 51 page)

HP LASER PRINTERS 4, 4+, 4P, 4SI, 4V, 5

1. SIMM malfunction.

2. Replace simm's chip.

3. Replace formatter board.

HP LASER PRINTERS 4L, 5L

1. An error has been found in the RAM.

2. Defective or incompatible memory card.

3. Defective formatter board.

HP LASER PRINTERS 5P, 5SI

1. SIMM malfunction.

2. Replace simm's chip.

3. Replace formatter board.

HP LASER PRINTERS 1200, 2200, 3100, 3200, 4100 ERROR 53.XX

1. Temporary error. DIMM error.

2. Unsupported memory size.

3. Invalid DIMM speed.

4. DIMM RAM parity error.

5. Try the dimm in a different slot.

6. Unable to make a temporary mapping in the printer.

7. Replace all the DIMM memory.

8. MAKE SURE YOU ARE NOT TRYING TO USE COMPUTER MEMORY IN YOUR LASER PRINTER. IT IS NOT A COMPUTER!

9. Replace formatter board.

HP LASER PRINTER 2015 ERROR 53.XX.XX

1. Verify that the DIMM is correctly seated.

2. If the error persists, replace the DIMM.

HP LASER PRINTER 2300, 2410, 2420, 2430 ERROR 53.XX.ZZ

1. The printer has a problem with the memory DIMM.

2. Unsupported memory presence detect bad.

3. Reseat all the memory on the mother board.

4. Unsupported memory size. Means the DIMM you trying to put in slot is too many MB. per DIMM for the printer. Basically you are trying to put computer memory in to a printer, GET IT OUT AND GO BUY HP PRINTER MEMORY!

HP LASER PRINTER P3005 ERROR 53.10.01

1. The memory DIMM is not a supported DIMM.

2. Install a supported DIMM.

HP LASER PRINTER 3027M/3035

1. A problem exists with the device memory. The DIMM that caused the error will not be used.

2. Turn the device off and then replace the DIMM that caused the error.

3. If after replacing the DIMM and the message persists, replace the formatter.

HP LASER PRINTER 3200

1. Disconnect the power cable from the product, wait at least 30 seconds, then reconnect the power cable and wait for the product to initialize.

2. If the error persists, replace the formatter.

HP LASER PRINTER 4345MFP, 5025MFP, 5035MFP

1. A problem exists with the MFP memory. The DIMM that caused the error will not be used. 

2. You might need to reseat or replace the specified DIMM.

3. Turn the MFP off, and then replace the DIMM that caused the error. Make sure that you are using the correct DIMM for this MFP. 

HP LASER PRINTER 5000, 5100, 5150, 5200

1. Error has occurred on some memory.

2. Unsupported memory.

3. Unrecognized memory.

4. Exceeded maximum ram size

5. Invalid dimm speed.

6. Remove dimm and put into different slot.

7. Replace bad dimm chip that caused the error

HP LASER PRINTER 4200, 4300, 4250, 4350

1. An error occurred in the printer memory.

2. Unsupported memory.

3. Unrecognized memory.

4. Unsupported memory size. Means the DIMM you trying to put in slot is too many MB. per DIMM for the printer. Basically you are trying to put computer memory in to a printer, GET IT OUT AND GO BUY HP PRINTER MEMORY!

5. Reset all DIMMS.

6. Replace the bad DIMMS.

7. Replace the mother board.

HP LASER PRINTER 8100, 8150

1. Error has occurred on some memory.

2. Unsupported memory.

3. Unrecognized memory.

4. Exceeded maximum ram size

5. Invalid dimm speed.

6. Dimm rom needs to be mapped to an unsupported address.

7. Dimm address conflict.

8. Unable to make a temporary mapping.

9. Remove dimm and put into different slot.

10. Replace bad dimm chip that caused the error

HP COLOR LASER PRINTER 4500, 4550

1. Temporary dimm error.

2. Replace dimm chip.

3. Replace formatter board.

HP COLOR LASER PRINTER 4600, 5500 ERROR CODE 53.XO.ZZ 

1. An error has occurred in the onboard RAM.

2. Turn the printer on and then off.

HP COLOR LASER PRINTER 4600, 5500 ERROR CODE 53.XY.ZZ

1. Error has occurred on some memory.

2. Unsupported memory.

3. Unrecognized memory.

4. Exceeded maximum ram size

5. Invalid dimm speed.

6. Remove dimm and put into different slot.

7. Replace bad dimm chip.

8. Replace the formatter board.

HP COLOR LASER PRINTER 4600, 5500 ERROR 53.10.05

1. A DIMM is installed in both 168 - pin DIMM slot 4 and 100 - pin DIMM slot 5.

2. Remove one or all the DIMMS, or move one of the DIMMS to a different slot. 

HP COLOR LASER PRINTER 8500 

1. Temporary dimm error 

2. Try dimm chip in a different slot. The DRAM DIMMS must be installed in synchronous pairs in adjacent slots, with the same size and speed in both slots. Only SDRAM is supported.

3. Replace dimm chip.

4. Replace formatter board.
.

HP LASER PRINTER 9000
, 9040, 9050MFP

1. Temporary dimm error 

2. Try dimm chip in a different slot

3. Replace dimm chip.

4. Replace formatter board.

 

Home | Error Codes | Hp Printers | Toner Cartridges | Hp Printer Accessories | Hp Plotters
 

Copyright © 2011 Advanced Laser Services, Inc.